Position Monitored Ball Valves
Designed and made in New Zealandm TruDesign Certified Ball Valves are specifically designed for use in marine applications above and below the water line.
- Certified to ISO 9093-2 by the International Marine Certification Institute (IMCI, Belgium) when fitted to TM Skin Fittings (Thru Hulls)
- Comply with ABYC H-27 standards when used in conjunction with the Skin Fittings (Thru Hulls).
- Certified by Bureau Veritas to ISO 9093-2.
Features
- Allows remote monitoring of up to four Ball Valves (per sea cock display panel) in the open or closed position.
- Can be wired into or part of an engine or generator start "interlock" to ensure they don't start without cooling water available.
- Manufactured from a glass-reinforced Nylon composite - High strength, tough and light weight.
- Immune to corrosion & electrolysis - No corrosion breakages, increased safety.
- Electrically non-conductive. No electrical bonding.
- Suitable for use on all hull types - aluminium, steel, wood or FRP.
- The ball and sealing rings utilise a PTFE polymer to ensure a smooth action and minimal fouling of the internal ball.
- Can be "locked" in the closed position to comply with toilet waste outlet regulations. US Coast Guard Regulation 33 CFR 159.7 and ISO Standard 8099 for locking of toilet waste outlets
- Large operating temperature range - From -40°C to+ 110°C ( for Ball Valve only)
- Available in both BSP and NPS thread forms (Contact us for Special Order of NPT fittings)
- U.V resistant - Will not degrade or discolour from the sun's ultraviolet rays.
- 100% leak tested before leaving factory.
Display Panel
- The Ball Valve Display Panel is supplied with the following;
- Installation instructions
- 2 x hook-up wire with connector- 2.Sm (8.2')
- Mounting screws and covers
- Sticker Sheet with the following options
The Position Monitoring function switches state when the Ball Valve is in the open position.
- Supply voltage 9.5 - 12V DC
- Maximum switching current- S00mA
- Wire length- 2m (6.5')
